1. The signal to noise ratio of data signal and tracking error signal are improved at the same time.

2. Multi-valued read-only storage location with improved signal-to-noise ratio

3. The Binned example also highlights how binning improves signal to noise ratio

4. The signal-to-noise ratio determines the of telecommunication systems (e.g., radio receivers).

5. Mutual information based signal to interference plus noise ratio estimator for radio link monitoring

6. However, note that reducing the shunt resistance will degrade the signal - to - noise ratio.

7. Integrating analog to digital conversion and digital smoothing will improve the signal to noise ratio.

8. Four observations were excluded because of low signal-to-noise ratio or background subtraction problems.

9. Also, the signal noise ratio can be determined using the measurement deviation amplitude.

10. Biasing and erasing apparatus and method for a magnetic tape recording device to improve signal-to-noise ratio

11. These have already resulted in an ADC with significant increases in signal-to-noise ratio (SNR, an indication of the ‘power’ of the signal compared to the noise) relative to conventional systems.

12. Later in the logs, there's additional information about the strength of the available connections, including the MAC address of the access point, frequency of the signal, noise and signal levels, and signal-to-noise ratio:

13. Antenna Arraying is the combining of the output from several antennas in order to improve the signal-to-noise ratio (SNR) of the received signal

14. Antenna Arraying is the combining of the output from several antennas in order to improve the signal-to-noise ratio (SNR) of the received signal

15. It is possible to detect individual pulses from this millisecond pulsar with high signal-to-noise ratio in unbroken trains.

16. The IF- Amplifier of a radar receiver determines the gain, signal-to-noise ratio, and effective bandwidth of the receiver.

17. It utilizes spectral envelope estimation to obtain envelope and peak signal and calculates signal-to-noise ratio of speech harmonics in iterate form under least square estimate criterion.

18. In case of agglomerated yeast cells the signal-to-noise ratio was significantly increased in comparison to Raman spectra of the suspension.

19. Moreover, in the range between 900 nm and 1000 nm, InGaAs has a much better signal to noise ratio than Ag-O-Cs.

20. Minimizing sampling of the adipose layer greatly reduces interference contributed by the fat band in the sample spectrum, increasing signal-to-noise ratio.

21. [ strange radio signal, atmospheric noise ]

22. Thereby, its high permittivity is suitable for electrical impedance matching and its high sensitivity for good efficiency or signal/noise ratio.

23. Meanwhile post - stack noise removing help improve signal - to - noise further and attenuating noise arousing from processing.

24. The active noise reduction system comprises an input transducer for transducing acoustic noise to a noise signal.

25. In order to use the statistic dependencies available in the source signal for another gain in the signal-to-noise ratio, the differential pulse code modulation (DPCM) is combined with spherically logarithmic quantization.

26. Pixel Binning is the process of combining the electric charge from adjacent CMOS or CCD sensor pixels into one super-pixel, to reduce noise by increasing the signal-to-noise ratio in digital cameras.

27. An introduction to antenna Arraying in the Deep Space network Antenna Arraying is the combining of the output from several antennas in order to improve the signal-to-noise ratio (SNR) of the received signal

28. The ability to count every photon absorbed not only takes the signal-to-noise ratio to its quantum limit but would also facilitate decreased doses of radiation.

29. For example, the AF is significantly better than Canon and the signal/noise ratio ranks a class higher than Sony, just to mention two things.

30. Pixel Binning is a clocking scheme used to combine the charge collected by several adjacent CCD pixels, and is designed to reduce noise and improve the signal-to-noise ratio and frame rate of digital cameras

31. Acoustic emission toughness testing having smaller noise ratio

32. In addition, Audigy 2 supported up to 6.1 (later 7.1) speakers and had improved signal-to-noise ratio (SNR) over the Audigy (106 vs. 100 decibels (A)).

33. Then why is the signal an animal noise?

34. System for producing a substantially noise-free signal of an acoustic sound, and for producing a sound, the sound including a desired sound and an anti-phase noise sound, the anti-phase noise sound being in anti-phase relative to a noise, the system including an acoustoelectric transducer, a reference-acoustoelectric transducer and an audio controller coupled with the reference-acoustoelectric transducer and the acoustoelectric transducer, wherein the acoustoelectric transducer produces a noise bearing sound signal by detecting the acoustic sound and the noise, wherein the reference-acoustoelectric transducer produces the reference noise signal by detecting the noise in a noisy environment and wherein the audio controller produces the substantially noise-free signal, according to the reference noise signal and the noise bearing sound signal.

35. Device and method for influencing an audio signal according to ambient noise

36. Absolutely secure signal transmission by means of thermal noise

37. The results are discussed in terms of noise admixture to the signal.

38. Setting such pulse frequency to a low level acoustic noise frequency allows the signal-to-noise response to be greatly increased.

39. For example, the metrics may relate to (1) an overall channel capacity for all transmission channels used for the symbol stream, or (2) an equivalent signal-to-interference noise ratio (SNR) of an Additive White Gaussian Noise (AWGN) channel modeling these transmission channels.

40. Finally, a simulative example is given, which is extracting noise signal from mixture of noise signa...

41. The broad-band amplifier (5) feeds a buffer stage (6) in which the fractions of the continuous ground noise signal resulting from the cutting noise and frictional noise contained in the noise emission signal are separated from the pulsed machining stop signal of higher amplitude superimposed on the latter.

42. Method and user equipment for transmitting uplink signal according to adjacent channel leakage ratio

43. Echo cancellation and noise reduction adaptation during ringing signal playback

44. According to the invention, a histogram of the statistical signal distribution is first created from a data signal that has been degraded by Gaussian noise and for example, interference noise.

45. Ensemble Averaging is a data acquisition method that enhances the signal-to-noise of an analytical signal through repetitive scanning

46. Cascaded Noise Figure & Noise Temperature: Noise figure (NF) is the increase in noise power of a device from the input to the output that is greater than the signal gain

47. While strain/strain rate imaging offers very precise analysis of regional left ventricular function, it also requires intensive postprocessing, is limited by an unfavorable signal to noise ratio and a major angle dependency.

48. An analog signal must clearly exceed the noise amplitude in order to become detectable.

49. But more generally, this noise is something that corrupts the signal.

50. However, they have high installation costs and leave wires vulnerable to ambient signal noise corruption.

51. The YIG-oscillator is used as a low-noise microwave signal source.

52. In some instances, low signal dynamics gave rise to slightly lower MMLs than white noise.

53. Active noise cancellation is combined with spectrum modification of a reproduced audio signal to enhance intelligibility.

54. Also convincing are also the signal/noise ratios over the entire ISO range.

55. Today, the usual low noise design is to chose transistor and its quiescent point in order to ensure that the noise resistance equals the signal source resistance.

56. The application of window function as a tool for lineshape correction and signal-to-noise ratio (SnR) enhancement is rarely discussed in Chirped spectroscopy, with the only exception of using Kaiser-Bessel window and trivial rectangular window

57. A method is provided to estimate image and video noise of different types: white Gaussian (signal-independent), mixed Poissonian-Gaussian (signal-dependent), or processed (non- white).

58. An absolute noise for a plurality of points of the measured signal is estimated.

59. So they need a way to increase the energy level of the signal, to separate it from the noise.

60. The ILD is utilized by a noise reduction system to enhance the speech of the primary acoustic signal.

61. In electronics terms, Crosstalk occurs when unwanted speech or signal noise manifests in a communication

62. Mixed-signal and radio frequency integrated circuit designers are often confronted with noise-coupling issues.

63. 5.1.5. an acoustic signal is not be used if there is too much ambient noise;

64. The histogram resembles a Gaussian distribution (2, 3) provided that the other signal noises, for example interference noise do not amount to a multiple of the Gaussian noise (1).

65. As the name implies, wideband FM (WFM) requires a wider signal bandwidth than amplitude modulation by an equivalent modulating signal; this also makes the signal more robust against noise and interference.

66. Using this technique the line is more tolerant of errors caused by noise and signal loss.

67. The invention relates to a method for controlling the shaping of encoding noise during the ADPCM encoding of a digital audio input signal. The noise-shaping is carried out through the use of feedback that comprises filtering noise.

68. The internal scatter of the Abundances within clusters indicates that abundance precision is generally between 0.05 and 0.09 dex across a broad temperature range; it is smaller for some elemental Abundances within more limited ranges and at high signal-to-noise ratio.

69. In addition, they use a wide signal bandwidth, which can handle exceptional noise interference, providing reliable results.

70. Before computer processing, nystagmus signals are analog filtered to minimize physiological and/or electrical noise, eventually corrupting the eye movement signal.

71. Active noise Cancelling relies on a sophisticated proprietary electronics approach using microphones both inside and outside the earcups to monitor the sounds around you and instantly produces an opposite signal to cancel the noise.

72. Therefore, the signal processing apparatus and method can reliably exclude time delay generated when the noise is removed.

73. The cause is not signal splatter; the noise which annoys the deaf is at a much lower frequency.

74. Audiometers are calibrated so that a 10-dB masking noise will block a 10-dB pure-tone signal

75. Strength of the anti-noise signal is adjusted gradually, rather than abruptly, in proportion to decreasing or increasing sound pressure level (SPL) of the background noise, during inactivation or activation of the ANC process.

76. The receive signal is correlated with the (SBB,i) transmit signal in order to determine an amplitude ratio, a phase difference and a runtime difference for the selected transmit path in relation to a reference transmit path.

77. Signal is in low frequency, while noise in high frequency and minutia in image is also in this area.

78. A noise Blanker is a device that detects pulses and blocks the signal during the time of each pulse

79. Keysight’s high-performance Arbitrary waveform generators use low noise clocks which provide unmatched performance and high-quality signal generation to achieve superior fidelity

80. The improvement of the signal-to-noise ratio and the contrast-amplification leads to a sensitivity at least 10 times greater for the system of the visual cells 1–6 than for the visual cells 7 and 8 when these are compared on the level of the lamina ganglionaris.